

Brand new Dell DPS-460DB-16 A Power Supply.All power supplies are tested by our in house technicians and they are guaranteed to function properly.
For Dell XPS 8700 460Watt Power Supply 0J98H5 D460EM-00 DPS-460DB-16A
Max Output Power: 460W
Form Factor: ATX
AC Input: 100-240V ~ 5.0A, 50/60Hz
Power Factor Correction: APFC (Active PFC)
DC Output Rails:
+12.0VA: 18.0A
+12.0VB: 16.0A
+12.0VC: 8.0A
+3.3V: 17A
+5V: 25A
+5VSB (aux): 3.0A
Dimensions: 150mm x 140mm x 86mm
Connectors
(1) 24-Pin ATX Connector (approx. 11.5")
(1) 4-Pin 12V CPU Connector (approx. 20")
(1) 6-Pin PCIe Connector (approx. 11" on same cable as 6+2)
(1) 8-Pin (6+2) PCIe Connector (approx. 14" on same cable as 6-pin)
(1) Micro SATA Optical Connector (P14) (approx. 18" on same run as SATA lead)
(4) SATA Power Connectors (mixed spacing on shared leads)
Part Number:J98H5,0J98H5
MPN:D460EM-00,DPS-460DB-16 A
Compatible Models
✔ Inspiron: 560 Mini Tower (MT)
✔ XPS: 7100, 8300, 8500, 8700, 8900, 8910, 8920

1.Remove the dead pc power supply Once you've disconnected all the leads, look at the rear of the case and find the three or four screws holding the power supply in place. Remove them, then gently lift out the PS, making sure that the cabling doesn't get tangled on, say, a RAM module or expansion card and accidentally pull it loose.
2. Install the new dell DPS-460DB-16A Pc power supply Out with the old, in with the new. Make sure the replacement Pc power supply is set to the correct voltage. Once the old PS is out, put the new one in its place and screw it in. Now just reverse the steps you performed: connect the leads to their respective outlets, replace any extracted components, and consult your photos to make sure you've left no lead unplugged. (You'd be surprised how easy it is to forget, say, the DVD lead, especially when you've spent 10 minutes trying to wedge in that pesky front-panel lead.)
3. Fire it up Before you close up the case, make sure everything works. Connect the power cord to the Pc power supply, plug in your monitor and keyboard, and fire up the machine. Unless you've failed to connect the main leads to the motherboard, it should come right to life, just like before. Let it boot completely, then check to make sure there's power to the optical drive(s) and, if applicable, the front panel.