Brand new Dell H220AS-00 L220AS-00 Vostro 270S inspiron 660S 220W Power Supply

• Product Details
• Power Supply Tips

Product Details

Please make sure that you are ordering the correct power supply. All of the compatible models listed below come in different sizes and each size has a different power supply. Please check the part #'s, pictures and specifications carefully to make sure that you are ordering the correct power supply.
This power supply has the following connectors:

Connectors:
P1: 24-Pin ATX Power r(Could be 20-Pin + 4-Pin)
P2: 4-Pin ATX Power
P3: 1x SATA Power
P4: 1x SATA Power

Part Numbers:
L220AS-00 , H220AS-00 ,H220NS-01 ,DPS-220UB ,CPB09-D220R ,PS-5221-6 ,PS-5221-8 ,PS-5221-9 ,DP/N:R82H5 ,TTXYJ ,O429K9.

Compatible For Dell Desktop:
Dell V270S ,Dell INSPIRON 660S ,Dell 3647 ,GATEWAY SX2300 ,GATEWAY SX2310 ,GATEWAY SX2311 ,GATEWAY SX2800 ,GATEWAY SX2801 ,GATEWAY SX2802 ,GATEWAY SX2840 ,GATEWAY SX2841 ,GATEWAY SX2850 ,Aspire X1200 ,Aspire X1300 ,Aspire X1700 ,Aspire X1800 ,X3200 ,Aspire X3300 ,Aspire X3810 ,Aspire X5300 ,Aspire X5810 ,eMachines L1200 ,eMachines L1210 ,eMachines L1320 ,eMachines L1700 ,Veriton X270 ,Veriton X480G ,Acer AX1200 ,Acer AX1700 ,eMachines EL1200-05w ,Machines EL1200-06w ,Machines EL1200-07w ,Machines EL1210-01e ,Machines EL1210-09 ,Machines EL1210-11 ,Machines EL1700 ,Machines EL1700 ,Machines EL1300G-01w ,Machines EL1300G-02w

HOW TO REPLACE YOUR PC POWER SUPPLY.

1.Remove the dead pc power supply Once you've disconnected all the leads, look at the rear of the case and find the three or four screws holding the power supply in place. Remove them, then gently lift out the PS, making sure that the cabling doesn't get tangled on, say, a RAM module or expansion card and accidentally pull it loose.

2. Install the new dell H220AS-00 Pc power supply Out with the old, in with the new. Make sure the replacement Pc power supply is set to the correct voltage. Once the old PS is out, put the new one in its place and screw it in. Now just reverse the steps you performed: connect the leads to their respective outlets, replace any extracted components, and consult your photos to make sure you've left no lead unplugged. (You'd be surprised how easy it is to forget, say, the DVD lead, especially when you've spent 10 minutes trying to wedge in that pesky front-panel lead.)

3. Fire it up Before you close up the case, make sure everything works. Connect the power cord to the Pc power supply, plug in your monitor and keyboard, and fire up the machine. Unless you've failed to connect the main leads to the motherboard, it should come right to life, just like before. Let it boot completely, then check to make sure there's power to the optical drive(s) and, if applicable, the front panel.